Chapters0/45 ▾
- 1.Intake & Write-Up0/4
- 2.Status, Invoice & Delivery0/4
- 3.Complaints & Professional Conduct0/4
- 4.Estimates & Prioritised Recommendations0/4
- 5.Communicating Value & Objections0/4
- 6.Vehicle Systems & Components0/4
- 7.Maintenance Schedules & Procedures0/4
- 8.Warranty, Bulletins & Recalls0/4
- 9.Vehicle Identification0/4
- 10.Workflow, Scheduling & Sublet0/5
- 11.Internal Communication & Quality0/4
Chapter 1 · Lesson 3 of 4
Writing the concern so a technician can duplicate it
1 min read
The concern line belongs to the consultant, and it has one job: let a technician reproduce what the customer experienced. Write it in the customer's own terms and add the conditions.
When does it happen? Hot or cold engine, first drive of the day, after a short stop, at what speed, in what weather? Those facts make an intermittent problem testable.
Example: a customer says the car hesitates when merging onto the freeway, but only on hot afternoons. A strong concern line reads: hesitation on hard acceleration at highway merge, hot afternoons, engine fully warm.
A weak line reads: check fuel system. The first gives the technician something to test; the second is a guess. Asking the customer to imitate a noise or ride along on a road test is also good intake, because it gathers conditions without naming a cause.
Check yourself
1. A customer reports that the engine sometimes will not start. Which question does the most for the technician who has to duplicate it?
2. A customer says, "it makes a grinding noise when I back out of the driveway in the morning." The consultant is fairly sure a brake component is worn. How should the concern line read?
Facts checked 2026-11-16 · Sources: ASE Automobile Service Consultant (C1) Study Guide 2026, ASE C1 Automobile Service Consultant test page
ASE C1 Service Consultant cheat sheet: every key fact on one page →