Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/22 ▾
← Weather & METAR/TAF

Chapter 3 · Lesson 3 of 4

Density altitude, stability and fog

1 min read

Density altitude is pressure altitude corrected for nonstandard temperature. It is not a height you fly; it describes how thin the air feels to your propellers.

Air gets less dense when it is warmer, when pressure is lower, and when it is more humid, because water vapor is lighter than the nitrogen and oxygen it replaces. Thin air means less thrust for the same motor speed, so on a hot afternoon at a high site expect slower climbs, less payload and shorter flights.

Stable airUnstable air
Layered stratiform cloudsCumuliform clouds
Steady precipitationShowers
Smooth airTurbulence
Poor visibility from haze or smokeGood visibility

A temperature inversion, where air warms with height, is very stable and traps haze, smoke, fog and low clouds beneath it. On a clear, calm night with a small temperature and dew point spread, the ground cools the air until it saturates and radiation fog forms by morning.

Air masses combine these ideas. Moisture supplies the cloud and stability decides its shape: moist unstable air gives cumulus, showers and turbulence; moist stable air gives stratus, fog and smooth air with poor visibility; dry stable air is clear and smooth but can hold smoke and haze near the ground.

Check yourself

1. Which combination of conditions produces the HIGHEST density altitude at a given launch site?

2. What weather is typically produced by a MOIST, UNSTABLE air mass?

Facts checked 2026-11-16 · Sources: FAA-H-8083-28: Aviation Weather Handbook, FAA-G-8082-22: Remote Pilot Small Unmanned Aircraft Systems Study Guide, 14 CFR 107.51: Operating limitations for small unmanned aircraft (eCFR)

FAA Part 107 Drone Pilot cheat sheet: every key fact on one page →