Quibank app: now on the App Store — free, works offline. Get the app ↗

Chapters0/22 ▾
← Regulations & Operating Limits

Chapter 1 · Lesson 3 of 5

Altitude, speed, visibility and cloud limits

1 min read

Section 107.51 holds the numbers the exam asks about most. Learn them as a set, and pay attention to how each one is measured.

LimitRule
Altitude400 feet AGL, or up to 400 feet above a structure while within 400 feet of it
Speed87 knots (about 100 mph) groundspeed
Visibility3 statute miles, seen from the control station
Clouds500 feet below and 2,000 feet horizontally

Two worked examples. A 250-foot water tower can be inspected up to 650 feet AGL, but only while the drone stays within 400 feet of the tower.

A drone cruising at 80 knots airspeed with a 15-knot tailwind has a groundspeed of 95 knots, which breaks the 87-knot limit even though the airspeed looks legal. The speed limit is groundspeed, so wind counts.

Altitude is not the only gate. Section 107.41 requires ATC authorization before flying in Class B, C or D airspace, or in the surface area of Class E airspace designated for an airport, even at 50 feet. Class G and other Class E airspace need no authorization.

Check yourself

1. You have been hired to inspect a 600-foot-tall antenna tower. Operating within a 400-foot radius of the tower, what is the highest altitude at which you may legally fly under §107.51?

2. You are hired to photograph a building located within the lateral boundaries of the surface area of Class D airspace. Under Part 107, before conducting the flight you must:

Facts checked 2026-11-16 · Sources: 14 CFR Part 107: Small Unmanned Aircraft Systems (eCFR), FAA-S-ACS-10B: Remote Pilot Small UAS Airman Certification Standards, FAA: Remote Identification of Drones

FAA Part 107 Drone Pilot cheat sheet: every key fact on one page →