Chapters0/22 ▾
Chapter 4 · Lesson 3 of 4
Performance: weight, density altitude and aircraft type
1 min read
In a steady hover, total rotor thrust equals the aircraft's weight. Add 2 pounds of payload and the rotors must make 2 more pounds of thrust, which takes higher motor speed and more current, so the same battery empties sooner. Weight always costs endurance on a multirotor.
Density altitude is pressure altitude corrected for nonstandard temperature, and performance follows air density. High elevation, high temperature and high humidity all make the air thinner. Propellers make thrust by pushing air down, so thin air gives less thrust per revolution and the motors draw more current to compensate.
The published maximum takeoff weight is a design limit, not a promise: a drone loaded right to that limit at a 6,000-foot site on a hot, humid afternoon may still not perform well enough, and you may need to remove payload.
Aircraft type matters when power fails. A fixed wing keeps making lift from its forward speed, so it can glide toward a landing spot. A multirotor gets all its lift from powered rotors whose small blades cannot autorotate, so lift disappears almost at once.
Check yourself
1. With pressure and temperature unchanged, how does an increase in relative humidity affect air density and small UAS performance?
2. A small UA is loaded exactly to its maximum takeoff weight for a job at a 6,000-foot-elevation site on a hot, humid afternoon. What should the remote PIC conclude?
Facts checked 2026-11-16 · Sources: FAA-H-8083-25: Pilot's Handbook of Aeronautical Knowledge (Ch. 5 and 11), FAA-G-8082-22: Remote Pilot Small Unmanned Aircraft Systems Study Guide, FAA-S-ACS-10B: Remote Pilot Small UAS Airman Certification Standards
FAA Part 107 Drone Pilot cheat sheet: every key fact on one page →