Chapters0/68 ▾
- 1.Medical Terminology & Anatomy0/5
- 2.ICD-10-CM Guidelines & Conventions0/5
- 3.Evaluation & Management (E/M)0/5
- 4.Anesthesia0/5
- 5.Surgery: Package & Cross-Section Rules0/5
- 6.Surgery: Integumentary & Musculoskeletal0/5
- 7.Surgery: Respiratory, Cardiovascular & Digestive0/5
- 8.Surgery: Urinary, Reproductive, Endocrine & Nervous0/5
- 9.Radiology0/5
- 10.Pathology & Laboratory0/5
- 11.Medicine0/5
- 12.Modifiers & HCPCS Level II0/5
- 13.Compliance & Regulatory0/4
- 14.Case Studies0/4
Chapter 4 · Lesson 1 of 5
Anesthesia time and how units are counted
1 min read
Surgery codes are paid from relative value units on the physician fee schedule, but anesthesia is paid by units. Under the ASA Relative Value Guide convention used by many commercial payers, the total is base units for the procedure, plus time units, plus modifying units for physical status and qualifying circumstances.
Medicare's formula uses only base units and time units. The total units are then multiplied by a conversion factor.
- Time starts when the anesthesia provider begins preparing the patient for induction in the operating room or an equivalent area. The pre-anesthesia evaluation in the holding area is part of the base units, not time.
- Time ends when the provider is no longer in personal attendance and the patient can safely be placed under postoperative supervision. The end of surgery and leaving the room are not the end point.
Example: a Medicare contractor that divides minutes by 15 and rounds to one decimal turns 112 minutes into 112 / 15 = 7.47, reported as 7.5 time units.
For a commercial payer, a case with 7 base units, 60 minutes (4 time units) and a P3 patient that the payer's schedule values at 1 unit totals 7 + 4 + 1 = 12 units. Always use the rounding method and unit values the question gives you.
Check yourself
1. A Medicare claim reports 97 minutes of anesthesia time. The Medicare contractor divides actual minutes by a 15-minute unit and rounds the result to one decimal place. How many time units result?
2. A Medicare claim is filed for a case the anesthesiologist performed personally. The anesthesia code has 5 base units. The record shows: pre-op interview in holding at 11:30; anesthesiologist begins preparing the patient for induction in the OR at 11:48; incision at 12:05; closure at 12:50; patient safely handed off to PACU nursing care and the anesthesiologist leaves at 13:01. The anesthesiologist documents physical status P3. Using Medicare's method (actual minutes ÷ 15, rounded to one decimal place), how many total units are paid before the conversion factor is applied?
Facts checked 2026-11-15 · Sources: CMS Medicare Claims Processing Manual, Chapter 12 (physician and anesthesia services), CMS Medicare NCCI Policy Manual, AAPC: Taking the CPC exam
CPC Medical Coding cheat sheet: every key fact on one page →