Chapters0/35 ▾
Chapter 6 · Lesson 5 of 5
Physical-science investigations: questions, controls and trials
1 min read
Many questions in this pool ask about the experiment rather than the science fact. Start by naming what was changed (the independent variable) and what was measured (the dependent variable); the research question links them in that order.
If a student rolls the same ball down a ramp at three angles and times each run, the question is how the ramp angle affects the time, not the reverse.
| Design feature | Why it is there |
|---|---|
| Control (chalk in plain water beside chalk in vinegar) | Baseline showing what happens without the factor tested |
| Repeated trials, averaged | Reduce the effect of random error in any one measurement |
| Change only one variable | Any difference can be traced to that one cause |
Also watch for assumptions, which reasoning takes as true without measuring. Dating rock layers by superposition assumes the layers were never overturned. Conclusions should stay within the tested range; a trend from 10 to 40 coil turns does not predict an exact result at 200.
Check yourself
1. A student releases the same toy car from rest at the top of a ramp set to heights of 20 cm, 40 cm, and 60 cm. At each height she runs three trials and measures the car's speed at the bottom with a motion sensor. Her average speeds are 1.9 m/s, 2.8 m/s, and 3.4 m/s. Which research question does this investigation answer?
2. A student releases the same toy car from rest at the top of a ramp set to heights of 20 cm, 40 cm, and 60 cm. At each height she runs three trials and measures the car's speed at the bottom with a motion sensor. Her average speeds are 1.9 m/s, 2.8 m/s, and 3.4 m/s. Why did the student run three trials at each height and average the results?
Facts checked 2026-11-15 · Sources: HiSET Test at a Glance (TAAG): Science
HiSET cheat sheet: every key fact on one page →